Motorola ML910 - Manual (Page 134)

2. Insert a small rod, such as a straightened paperclip, into the drive’s manual-eject
hole and push firmly to release the tray.
3. Pull the tray out until fully extended and then remove the disk.
Power Management Problems
The computer does not enter standby/sleep mode automatically.
z
When your computer is connected to another device, it may not enter standby/sleep
mode if the connection is actively in use.
z
Make sure the standby/sleep time-out is enabled.
The computer does not enter standby/sleep mode immediately.
z
If the computer is busy performing tasks, it will only enter standby/sleep mode after
completing the tasks.
The computer does not resume from standby/sleep mode.
z
The computer automatically enters standby/sleep mode when the battery pack drops
to 3% of being fully discharged. Perform one of the following:
− Connect the AC adapter to the computer.
− Replace the empty battery pack with a fully charged one.
The computer does not enter sleep mode with the Fn+F10 hot keys.
z
Make sure the sleep function is specified on the sleep button.
Software Problems
An application program does not work correctly.
z
Make sure the software is correctly installed.
z
If an error message appears on the screen, consult the software’s documentation for
further information.
8-8 Troubleshooting