Miller Electric IH - Manual (Page 63)

OM-203 185 Page 59
8-5. Factory Set Parameters
If it becomes necessary to return to factory settings, the following sections list factory settings for the 2408 controller.
All settings can be accessed through the Goto screen. To access the Goto screen, proceed as follows:
Press Page to
AccS
LiSt
codE
0
Y
codE
1
Wait
2 sec.
codE
PASS
Goto
OPEr
Goto
ConF
to B
Goto
Edit
to B
Goto
Ful
to B
Press Scroll
After selecting the desired Goto screen, press the scroll button to display the menu.
Press the page button to move from left to right through the columns; press the scroll button to move down the column;
press the up or down arrow to change parameter settings, if necessary.
8-5-1. Controller Version Number
2400
V4.09
When the controller is first turned
on, the version number will display
breifly, and appear as shown.
Controller configuration
parameters vary based upon
version number. See appropriate
Section for the corresponding
version number.
Version Number
(V4.09 Effective w/Serial No. LC089021)