Installing the battery, Charging the battery, Turning your phone on – Motorola E1000 User Manual
Page 6: Adjusting volume, Making a call, Answering a call, Changing the call alert
16 - Getting Started
The rechargeable batteries that power this phone must be
disposed of properly and may need to be recycled. Refer to
your battery’s label for battery type. Contact your local
recycling centre for proper disposal methods.
Warning: Never dispose of batteries in a fire because they may
explode.
Installing the Battery
Your phone is designed to use only Motorola Original™
batteries and accessories.
1
2
3
Getting Started - 17
Charging the Battery
New batteries are shipped partially charged. Before you can use
your phone, you need to install and charge the battery as described
below. Some batteries perform best after several full charge/
discharge cycles.
Tip: You can safely leave the travel charger connected to your
phone after charging is complete. This will not damage the battery.
Turning Your Phone On
Action
1
Plug the travel charger into
your phone with the release
tab facing up.
2
Plug the other end of the travel charger into the appropriate
electrical outlet.
3
When your phone indicates
&KDUJH &RPSOHWH
, press the release
tab and remove the travel charger.
Action
1
Press and hold
o
for
2 seconds to turn on the phone.
2
If necessary, press
S
to scroll to the User Account you
want. Then press the
6(/(&7
key to select the account from the
list (stored on the SIM card).
18 - Getting Started
Adjusting Volume
Press the up or down volume keys to:
• increase or decrease earpiece
volume during a call
• increase or decrease
speakerphone volume during a call
• increase or decrease the ringer
volume setting when the home screen is visible
Tip: At the lowest volume setting, press the down volume key
once to switch to vibrate alert. Press it again to switch to silent
alert. Press the up volume key to cycle back to vibrate alert,
then ring alert.
• turn off an incoming call alert
3
If necessary, enter your SIM card PIN code and press the
2.
key to unlock the SIM card.
Caution: If you enter an incorrect PIN code 3 times in a row,
your SIM card is disabled and your phone displays
6,0 %ORFNHG
.
4
If necessary, enter your four-digit unlock code and press
2.
key to unlock the phone.
Tip: The unlock code is originally set to 1234.Your service
provider may change this number before you receive your
phone.
Action
Getting Started - 19
Making a Call
To make video calls, see p a g e29.
Note: You can make an emergency call even when the phone is
locked, or when a SIM card is not inserted (see pag e68).
Answering a Call
When you receive a call, your phone rings and/or vibrates and
displays an incoming call message.
Changing the Call Alert
In the home screen, press the down volume key to switch the alert
for incoming calls and other events to vibrate alert, then silent alert.
Press the up volume key to reset ring alert.
Press
To
1
keypad keys
dial the phone number
2
n
make the call
3
o
end the call and “hang up” the phone
when you are finished
Press
To
1
n
or
answer the call
',9(57
or
o
divert the call to your voicemail or call
divert number, as though your line was
busy
2
o
end the call and “hang up” the phone when
you are finished