Garmin FA168CPS - Manual (Page 7)

– 7 –
System Overview System Overview System Overview System Overview (Continued) (Continued) (Continued) (Continued)
Phone Access
• If included, a Phone Module permits you to access the system via a touch-tone
phone, either on-premises or by calling-in when away.
• You can receive synthesized voice messages over the telephone regarding the
status of the security system.
• You can arm and disarm the system and perform most function commands
remotely via the telephone, with voice confirmation provided after each command.
• Refer to the Phone Access User's Guide supplied with the Phone Module for
information regarding the use of this feature.
Paging Feature
• If programmed, the system can automatically send certain system condition
messages to up to four (FA168CPS) or two (FA148CP) pagers.
• The system can also automatically alert a pager if the system has not been
disarmed by a certain time (e.g., can let you know a child has not arrived home).
• You can also manually send a message to designated pagers.
Using the Voice Message Center (if Voice Keypad is installed) Using the Voice Message Center (if Voice Keypad is installed) Using the Voice Message Center (if Voice Keypad is installed) Using the Voice Message Center (if Voice Keypad is installed)
The Voice Keypads feature a voice message center
that lets you record and playback one message.
• The message can be up to 2.5-minutes long
• The message remains in the keypad’s memory
until a new message is recorded.
• The volume control of the message is adjustable.
• Refer to the procedures below when using the
Message Center functions.
FA560VKP-004-V0
VOLUME
KEY
VOICE
KEY
FUNCTION
KEY
STATUS
KEY
DOWN
VOLUME
PLAY KEY
AND
UP VOLUME
RECORD
KEY
MICROPHONE
A
B
C
D
6 4
7
BYPASS
9 CHIME
#
3 STAY
5 TEST
8 CODE
0
2 AWAY 1 OFF
MAX
READY
INSTANT
*
RECORD
STATUS
ARMED MESSAGE READY
PLAY VOLUME
VOICE FUNCTION
FA560
LCD
DISPLAY
FUNCTION
KEYS
LEDS
SPEAKER
Message Center Functions
To… Press these keys… Notes…
record a
message [#] FUNCTION + [0] VOICE + [1] RECORD The red MESSAGE LED lights.
Message remains in memory
until a new message is recorded.
end
recording [1] RECORD The red MESSAGE LED flashes,
indicating message waiting.
play a
message [#] FUNCTION + [0] VOICE + [3] PLAY The recorded message plays and
the red MESSAGE LED turns off.
adjust the
volume [#] FUNCTION + [0] VOICE + [2] VOLUME keys,
then press volume key [3]
↑ (up) or [6] ↓ (down)
Adjusting message volume also
adjusts status volume. Volume
cannot be adjusted while playing.