beautypg.com

Arming the system – Garmin FA168CPS User Manual

Page 16

background image

– 16 –

Arming the System

Arming the System

Arming the System

Arming the System

Arming Commands

Arming Commands

Arming Commands

Arming Commands

Before arming, close all perimeter doors and windows and make sure the Ready to Arm
message is displayed.

Modes of Arming

Mode

Press these keys…

Keypad Confirms By…

Stay

security code + [3] (STAY)

• three beeps

• armed STAY message displayed

• red ARMED indicator lights

Night-Stay

security code + [3] + [3]

• three beeps

• NIGHT-STAY message displayed

• red ARMED indicator lights

Instant

security code + [7] (INSTANT)

• three beeps

• armed STAY message displayed

• red ARMED indicator lights

• also note that entry delay is turned off.

Away

security code + [2] (AWAY)

• two beeps

, or, if programmed, beeping for

duration of exit delay

• armed AWAY message displayed

• red ARMED indicator lights
Leave the premises through an entry/exit
door during the exit delay period to avoid
causing an alarm. The keypad beeps rapidly
during the last 10 seconds of the exit delay
to warn you that it is ending.

Maximum

security code + [4] (MAXIMUM)

• same as Away (described above)
Note that entry delay is turned off.

Arming Ding: In addition to the keypad beeps, the external sounder emits a short “ding” sound after arming, if

programmed to do so. The ding confirms that the system is armed, and may occur immediately after the command or be
delayed (until arm/disarm report is sent or exit delay expires). Ask your installer about how this feature is set for your system.

Quick Arming
If "Quick Arming" was programmed by the installer, the

[#]

key can be pressed in place

of the security code when arming the system in any of its arming modes (except Night-
Stay). However, the security code must always be used when manually
disarming the system.

Function Key Arming
For any arming command, a function key may have also been programmed for your
system. If so, you can press and hold the appropriate function key for 2 seconds to arm
the system. See your installer for the designated functions (see Single Button
Arming
section).

Refer to the Accessing Other Partitions section for information on multi-partition
arming (FA168CPS).