Scheduling – Garmin FA168CPS User Manual

Page 35

– 35 –

Scheduling

About Scheduling

The system provides end-user schedules (programmable by master/installer only),
which can control various types of events.
• Each schedule causes a defined event to start and stop (when appropriate) at a

specified time.

• Schedules can be set to automatically repeat at various intervals.

• Schedules can be set for random starting, if desired.

• FA168CPS provides up to 16 user schedules; FA148CP provides up to 4 user schedules.

Creating Schedules

Alpha Displays:

+ [#] + [6] [4]

(Master

Code)

1 DISARMED
READY TO ARM

Enter a 2-digit schedule number from:
01-16 (FA168CPS) or 01-04 (FA148CP).

Press

[

∗] to continue.

ENTER SCHED NO.
00

QUIT

Enter the desired 2-digit event number from the
following list.

00 = clear the scheduled event

01 = turn a programmed output on or off

ENTER EVENT
CLEAR EVENT

(see

Using Device Commands section for a list of output device numbers used

in your system)

02 = set a user access schedule for one or more users

(see Security Codes section for an explanation of access groups)

03 = send a “latch-key” report to a pager if the system is not disarmed by a specified

time; message sent is “777-7777.”

04 = automatically arm the system in STAY mode at a specified time

05 = automatically arm the system in AWAY mode at a specified time

06 = automatically disarm the system at a specified time

07 = Display the word “REMINDER” at a specified time (if selected, the keypad

beeps every 30 seconds beginning when the word “REMINDER” is first
displayed, and the display alternates with the normal keypad display about
every 4-5 seconds. To stop the beeps and cancel the display once it starts,
simply press any key).

Press

[

∗] to continue.

4. For event number “01,” enter the output number

associated with this schedule.

Otherwise, this prompt is skipped.

Press

[

∗] to continue to the “Start” prompt shown on

the next page.

RELAY NUMBER
00