beautypg.com

Paging feature, About automatic paging – Garmin FA168CPS User Manual

Page 28

background image

– 28 –

Paging Feature

Paging Feature

Paging Feature

Paging Feature

About Automatic Paging

About Automatic Paging

About Automatic Paging

About Automatic Paging

Your system may be set up to automatically send alert messages to several pagers (up
to four for FA168CPS, up to two for FA148CP) as certain conditions occur in your
system.
• The following events can be programmed by your installer to be sent to the pagers:

arming and disarming

, alarms, and trouble conditions. (

reports when

arming/disarming from a keypad using a security code; auto-arming/disarming,
arming with assigned button, and keyswitch arming do not send pager messages.)

• You can also program the system to send an automatic pager message to alert you

in the event that someone has not arrived home (disarmed the system) within a
defined period of time (see the Scheduling section for details on programming a
“latch key report”).

• Your installer programs the pager phone numbers and reporting events.
• The pager message consists of a 7-digit system status code that indicates the type of

condition that has occurred.

• An optional, predefined 16-digit character string can precede the 7-digit system

status code; these characters can consist of a PIN no., subscriber account no., or any
additional data that you may wish to have sent to the pager.

• The pager display format is as follows:

Optional 16 digits

3-digit Event Code

И

И

И

И

И

И

И

И

AAAAAAAAAAAAAAAABBBCCCC

Е

Е

Е

Е

1-digit Partition No. + 3-digit Zone No. or User No.

A =

B =

C =

Optional 16-digits for
Account numbers,
PIN numbers, or any
other data;
programmed by the
installer, if required.

A 3-digit code that

describes the event
that has occurred
in your system
(see for event
codes table below)

A 1-digit Partition number plus a 3-digit Zone or User
number, depending on the type of event that has
occurred, where:
• alarms and troubles display zone number

• arming/disarming (opens/closes) display user number

The 3-digit Event Codes (BBB) that can be displayed are:

911 =

811 =

101 =

102 =

Alarms.

The 4-digit number
(CCCC) following this
code is the partition no.
and zone no. that
caused the alarm.

Troubles.

The 4-digit number
(CCCC) following this
code is the partition no.
and zone no. that
caused the trouble.

Open

(system disarmed).

The 4-digit number
(CCCC) that follows
this code is the
partition no. and user
no.
that disarmed the
system.

Close

(system armed).

The 4-digit number
(CCCC) that follows
this code is the
partition no. and user
no.
that armed the
system.

Ex. 1. 911 –10 04

= R eporting of an alarm (911) caused by a fault on zone 4 on Partition 1 (1004).

Ex. 2. 102 –20 05 = Reporting of a closing–system arming (102)– by user 5 in Partition 2 (2005).