Garmin FA168CPS - Manual (Page 12)

– 12 –
Entry/Exit Delays Entry/Exit Delays Entry/Exit Delays Entry/Exit Delays
Exit Delay Exit Delay Exit Delay Exit Delay
Exit delay gives you time to leave through the designated exit door(s) without setting
off an alarm. Exit delay begins immediately after arming your system in any arming
mode and Alpha Display keypads display the message “You May Exit Now.” When
“You may exit now” disappears, the system is fully armed. If programmed, a slow
beeping will sound during the exit delay period until the last 10 seconds, which then
changes to fast beeping (alerting you to the end of exit delay). If you cannot leave by
this time, you should stop, disarm the system, and start over to avoid a false alarm.
Exit Delay Restart. If you wish to open the entry/exit door to let someone in after
arming STAY, you can re-start the exit delay at any time – simply press the [
✱]
key, then let that person in (the perimeter zones remain armed). The system
automatically re-arms the entry/exit door when exit delay expires, which avoids
having to disarm the system and then re-arm it again. In addition, when the system
is armed AWAY, reopening and closing the entry/exit door before exit delay time
expires (e.g., reentering to get a forgotten item) will reset the exit delay time once.
Entry Delay Entry Delay Entry Delay Entry Delay
Entry Delays give you time to disarm the system when you re-enter through the
designated entrance door. There are two entry delays (if programmed). The first is for
your primary entrance and the second can be used for a secondary entrance, where a
longer delay is required to walk to the keypad to disarm the system.
You must disarm the system before the entry delay period ends, or an alarm will
occur. The keypad beeps during the entry delay period, reminding you to disarm the
system. The beeps stop when a code is entered, but will restart after about 15 seconds
if an invalid code is entered.
You can also arm the system with no entry delay at all by using the INSTANT or
MAXIMUM arming modes. These modes provide greater security while on the
premises or while away for extended periods of time.
You can also arm the system with no entry delay at all by using the INSTANT or
MAXIMUM arming mode. This mode provides greater security while on the
premises or while away for extended periods of time.
See your installer for your delay times.
Partition 1____________________________________________________________________________
Exit Delay: seconds; Entry Delay 1: seconds; Entry Delay 2: seconds
NOTE: Entry/Exit times set for partition 1 also apply to the common zone (FA168CPS).
Partition 2 (FA168CPS)_______________________________________________________________
Exit Delay: seconds Entry Delay 1: seconds Entry Delay 2: seconds