Gateway E-4650 - Manual (Page 43)

Replacing the system board 35
Replacing the system board
To replace the system board:
1 Open the case by following the procedure “To open the Gateway
Mid-Tower case:” on page 17.
2 Remove all of the expansion cards by following the procedure “To replace,
add, or reseat an expansion card:” on page 30.
3 Disconnect the power and data cables from the system board, noting their
locations and orientation. (You will reconnect the cables after you install
the new board.)
4 Remove the thumb screw using a screwdriver, coin, or your fingers.
Thumb screw