GE MULTILINK ML1200 - Manual (Page 260)

16–6 MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL
SNMP CHAPTER 16: SNMP
trap id= [type=] [host=]
[community=] [port=<1-65534>]
The show-trap command shows the configured trap stations in tabular format. The
id
argument is optional and is the number corresponding to the trap entry number in the
table.
show-trap [id=]
The com2sec command specifies the mapping from a source/community pair to a
security name. Up to 10 entries can be specified. This part of the View based Access
Control Model (VACM) as defined in RFC 2275.
com2sec id= [secname=] [source=]
[community=]
The group command defines the mapping from sec model or a sec name to a group. A
sec model is one of v1, v2c, or usm. Up to 10 entries can be specified. This part of the View
based Access Control Model (VACM) as defined in RFC 2275.
group id= [groupname=] [model=]
[com2secid=]
The show-group command displays all or specific group entries. The
id
argument is
optional and is the number corresponding to the group entry number in the table
show-group [id=]
The view command defines a manager or group or manager stations what it can access
inside the MIB object tree. Up to 10 entries can be specified. This part of the View based
Access Control Model (VACM) as defined in RFC 2275
view id= [viewname=] [type=]
[subtree=] [mask=]
The show-view command display all or specific view entries. The
id
argument is optional
and is the number corresponding to the view entry number in the table.
show-view [id=]
The user command adds user entries. The ML1200 allows up to 5 users to be added.
Currently, the ML1200 agent only support
noauth
and
auth-md5
for v3 authentication and
auth-des
for
priv
authentication.
user id= [username=] [usertype=]
[authpass=]
[privpass=] [level=] [subtree=]
The show-user command displays all or specific view entries. The id is optional and is the
number corresponding to the view entry number in the table.
show-user [id=]
16.2.2 Example
The following example shows how to configure SNMP.