Gateway WBR-100 - Manual (Page 21)

18
Chapter 2: Initial setup
www.gateway.com
4
If you selected DSL/ADSL Modem , select the type of Login (if any) used for
Internet access. Click Next to continue.
■ PPPoE - Type the User Name and Password provided by your ISP. Also,
indicate if you connect automatically, and the interval that elapses
before you are automatically disconnected. Click
Next to continue.
- OR -
■ PPTP (Europe only) - Enter the PPTP Server IP Address, the User
Name and Password provided by your ISP. Also, indicate if you
connect automatically, and the interval that elapses before you are
automatically disconnected. Click
Next to continue.
- THEN -
■ Indicate how the IP Address is assigned by your ISP. If they assign one
automatically each time you connect, select Dynamic . If they specify
an IP address that does not change, select Static and type the IP
address, the subnet mask, the default gateway, and the DNS. Click Next
to finish.
5
If you selected Telstra Bigpond Cable (Australia):
■ Enter the Server IP Address, the Login User Name and Login
Password provided by your ISP. Also, indicate if you connect
automatically, and the interval that elapses before you are
automatically disconnected. Click
Next to continue.
- THEN -
■ Indicate how the IP Address is assigned by your ISP. If they assign
one automatically each time you connect, select
Dynamic . If they
specify an IP address that does not change, select Static and type the
IP Address, the subnet mask, the default gateway, and the DNS. Click
Next to finish.
6
If you selected SingTel RAS:
■ Type the Login User Name and Login Password provided by your
ISP. Also, select the type of RAS Plan you have (512k or 256k Ethernet),
then indicate if you connect automatically (as needed), or if your
connection is always maintained. Click
Next to finish.