GCC Printers Elite XL - Manual (Page 41)

Setting up the Elite XL 1-27
Direct Ethernet connection
Elite XL 10BASE-2
connector
50 ohm
Terminator
(see step 4)
BNC “T” connector
(see step 2)
RG-58 cable
(see steps 5,6)
BNC “T” connector
(see step 2)
50 ohm
Terminator
(see step 4)
To connect the Elite XL to a computer with a BNC connector:
1. Switch off the computer and printer.
2. Attach one of the BNC “T” connectors to the BNC connector on the
Elite XL.
3. Attach the second BNC “T” connector to the BNC connector on the
computer.
4. Attach a terminator to one side of each of the BNC “T”
connectors.
5. Attach one end of the RG-58 coaxial cable to the unterminated
side of the BNC “T” connector on the printer.
6. Attach the other end of the RG-58 coaxial cable to the
unterminated side of the BNC “T” connector on the computer.
EtherTalk-capable computer
with 10BASE-T port.