Setup tones, Setup scanlist, Reference radio page – Garmin Rino 130 User Manual
Page 28
14
Reference
Radio Page
Setup Tones
Call Tone - When the
CALL
button is pressed, an attention tone is transmitted. This option
allows you to choose one of ten tones.
Roger Tone - When the
TALK
button is released, a tone is sent to signify the end of the trans-
mission. This option allows you to choose one of four tones, or set the tone to ‘Off’.
Ring Tone - When an incoming transmission is received, an attention tone will sound. This
option allows you to choose one of ten tones or set the tone to Off. The Ring tone will not
sound again until there has been 45 seconds of radio inactivity.
Vibrate - Choose from ‘On’ or ‘Off’ to have the unit vibrate when an incoming transmission is
received. Once received, the unit will not vibrate again until there has been 45 seconds of radio
inactivity.
On/Off Tone - Enable or disable the tone the unit makes when it is turned on and off.
Message Tone - Choose from ‘On’ or ‘Off’ to have the unit emit a tone when a message or note
is received.
Setup Scanlist
Refer to Scanning and Monitoring for complete information about this feature and the options
in this page.
Setup Scanlist Page
Setup Tones Page