beautypg.com

Appendix, Mapsource setup – Garmin Rino 130 User Manual

Page 117

background image

103

Appendix

To setup for data transfer:

1. Remove the Power/Data Port cover on the back of the unit by lifting up on the protective

cover on the back of the unit.

2. Connect the serial port connection on the cable to the PC serial port.
3. Connect the remaining cable connector to the back of the Rino 130 by orienting the slot on

the connector with indexing bar on the back of the unit. Then, slide the connector in place.
Be sure that the cable is pushed all the way into the back of the unit.

4. Turn on the Rino 130 and follow instructions for map data transfer provided in the

MapSource User’s Manual. See also the Interface Setup Page section for unit interface
settings.

MapSource Setup