Epson CX11NF - Manual (Page 130)

130
Notices
Important Safety Instructions
WARNING:
The cords included with this product contain chemicals, including lead, known to the
State of California to cause birth defects or other reproductive harm. Wash hands
after handling. (Posted in accordance with Proposition 65 in Cal. Health & Safety
Code § 25249.5 et seq.)
The lamp(s) in this product contain mercury. Please consult your state and local regulations
regarding disposal or recycling. Do not put in the trash.
Laser Printer Precautions
This printer uses laser technology. Follow the precautions below to ensure safe, efficient operation.
■ Unless specifically instructed in the documentation, be careful not to touch the fuser, which is
marked CAUTION HOT SURFACE. If you have been using the CX11N, the fuser may be very
hot.
■ Do not attempt to modify or take apart the toner cartridge. It cannot be refilled.
■ Do not touch the toner and avoid all toner contact with your eyes.
■ If toner is spilled, use a broom and dustpan or a damp cloth with soap and water to clean it up.
Because the fine particles can cause a fire or explosion if they come into contact with a spark, do
not use a vacuum cleaner.
■ Do not dispose of used toner cartridges and/or the fuser in fire, as they can explode and cause
injury. Dispose of them according to local regulations.
Before Operating Your CX11N
Read the following instructions before operating the CX11N.
When choosing a location and power source for the printer:
■ Use the CX11N in a well-ventilated area.
■ Do not place the CX11N on an unstable surface.
■ Do not put the CX11N where the cord will be stepped on.
■ Slots and openings in the cabinet and the back or bottom are provided for ventilation. Do not
block or cover them. Do not put the CX11N on a bed, sofa, rug, or other similar surface or in a
built-in installation unless proper ventilation is provided.
■ The interface connector for the CX11N (except the USB connector) is Non-LPS (non-limited
power source).