Grizzly G9953ZX - Manual (Page 21)

Ultimate Series Jointers -19-
Figure 18. Verifying outfeed table height with
straightedge.
Outfeed Table
Carbide cutter
is at the highest
point in its revo-
lution and is just
touching the
straightedge.
3. Position the edge of a straightedge on the
outfeed table so that it extends over the cut-
terhead (Figure 18).
4. Rotate the cutterhead by turning the cutter-
head pulley (
Figure 17).
5. Watch as one of the carbide cutters passes
under the straightedge. The carbide cutter
should just touch the straightedge WITHOUT
lifting the it off the outfeed table. If this condi-
tion is not present, refer to
Section 8: Service
Adjustments.
The outfeed table must be perfectly level with the
carbide cutters. Note—
You only need to verify
the outfeed table height with one of the carbide
cutters.
To verify the factory setting:
1. Unplug the machine from the power
source!
2. Open the access door (Figure 17) on the
back of the machine, just below the fence
adjustments .
Figure 17. Accessing the cutterhead pulley.
Cutterhead Pulley
Access Door
Carbide Cutter
To Outfeed
Table Alignment
(Models G9953ZX, G9953ZXF and G4815)