Stovax PR0741 - Manual (Page 19)

NOTE: IT IS IMPORTANT TO ENSURE THAT THE PANEL
LOCATES TIGHTLY AGAINST THE BURNER TRAY.
13
AR1931
8. E-STUdIo
ARRANGEMENT OF FUEL BED
COMPONENTS
ONLy USE ThE CORRECT TyPE AND QUANTITy OF
GRANITE ChIPPINGS. ALwAyS FOLLOw ThE FUEL BED
LAyOUT AS STATED IN ThESE INSTRUCTIONS. NEvER
ChANGE ThE LAyOUT FROM ThAT ShOwN hERE.
8.1 Arrange the granite chippings in the areas highlighted in
Diagram 14. Granite chippings should be evenly
distributed.
14
AR1768
8.2 Lean the granite chippings against the burner ledges to
disguise the ledges.
15
AR1769
8.3 Check that the port area. Arrow A, is clear of granite
chippings. This can be easily done by gently running a
screwdriver or similar object along this area. Diagram 16.
16
AR1768
A
NOTE: IT IS IMPORTANT THE GRANITE CHIPPINGS DO
NOT COVER THE PORT AREA IN BETWEEN THE BURNER
LEDGES.
8.4 Ensure that no pebbles over-hang or fill the pilot area,
Arrow C, Diagram 17.
NOTE: CHIPPINGS SHOULD NOT BE PLACED DIRECTLY
IN FRONT OF THE PILOT CROSS LIGHTING FLAME.
17
AR1770
C
8.5 Ensure that the fibre glass window seal on the box is intact,
then lower the glass window into the hooks on the box.
Secure the window using four screws in the retaining
bracket. See diagram 18.
18
AR 1767
19
INSTALLATION INSTRUCTIONS
INSTALLATION