Stovax PR0741 - Manual (Page 16)

TO ChANGE FROM ONE GAS TyPE TO ANOThER A
COMPLETE ENGINE ASSEMBLy AND DATA BADGE wILL BE
rEQUIrEd. SEE SECTIon 8 SErVICIng InSTrUCTIonS.
4.1 Before installation, ensure that the local distribution
conditions (identification of the type of gas and pressure)
and the adjustment of the fire are compatible. See
above tables.
4.2 Ensure that the gas supply is capable of delivering the
required amount of gas and is in accordance with the rules
in force. Please refer to the technical specification for the
correct working pressure for the gas used.
4.3 Soft copper tubing and soft soldered joints can be used but
must not be closer than 50mm (2”) to the underside of the
burner.
4.4 An isolation device is provided with the fire.
4.5 All supply gas pipes must be purged of any debris that may
have entered, prior to connection to the fire.
4.6 This appliance is intended for use on a gas installation with
a governed meter.
5. PREPARING ThE FIRE
5.1 Remove the glass window by unscrewing the four screws in
the retaining bracket. See diagram 1.
1
AR1377
5.2 Remove the five burner retaining screws and withdraw the
burner unit from its location, Diagram 2.
NOTE: IF REMOVING THE E-STUDIO BURNER, IT WILL
BE NECESSARY TO REMOVE THE DECORATIVE INNER
PANEL, SEE SECTION 7
2
Logic E-Box
AR1771
E-Studio
AR1372
16
1. UNPACKING
1.1 Remove the fire from its packaging, and check that it is
complete and undamaged.
1.2 Put the loose ceramic parts to one side so that they are not
damaged during installation.
2. CONTROL UPGRADE
2.1 Your fire is fitted with a control valve that can be easily
upgraded to battery powered remote control. This upgrade
can be fitted by anyone capable of simple DIY jobs and
requires no special training. This upgrade can be obtained
through your local Gazco stockist.
2.2 STANDARD REMOTE CONTROL This remote control can
control the fire after the pilot has been lit. It can turn the
main burner on and regulate it from low through to high and
back again. It can turn the main burner off leaving the pilot
burning. GAZCO PART NUMBER 8455.
2.3 PROGRAMMABLE THERMOSTATIC AND TIMER REMOTE
CONTROL. This remote control can control the gas fire after
the pilot has been lit. In MANUAL MODE it can be used to
turn the main burner on and manually regulate it from low
through to high and back again. It can be used to turn the
main burner off, leaving the pilot burning. In AUTO MODE it
will automatically regulate the room temperature to a preset
temperature. In TIMER MODE it will turn the fire on and off
according to preset programme and automatically regulate
the room temperature during the two periods.
GAZCO PART NO. 8456.
3. SAFETy PRECAUTIONS
3.1 This fire must be installed in accordance with the rules in
force, and used only in a sufficiently ventilated space. Please
read all instructions before installation and use of this fire.
3.2 These instructions must be left intact with the user.
3.3 Do not attempt to burn rubbish on this fire.
3.4 In your own interest, and those of safety, this fire must be
installed by a competent person in accordance with local and
national codes of practice. Failure to install the fire correctly
could lead to prosecution.
3.5 Keep all plastic bags away from young children.
4. INSTALLATION OF ThE GAS SUPPLy
NATURAL GAS @ 20mbar PROPANE @ 20mbar
8691CFCHUC P8691CFCHUC
8691MCUC P8691MCUC
8691PBUC P8691PBUC
INSTALLATION INSTRUCTIONS
INSTALLATION