Gateway 600YG2 - Manual (Page 30)

25
Replacing the hard drive in the hard drive kit
www.gateway.com
Replacing the hard drive in the
hard drive kit
Tools you need to complete this task:
Screws removed during this task:
To install a new hard drive into the kit:
1
Disconnect the AC adapter and modem and network cables and prepare
the notebook by following the instructions in
“Preparing your work space”
on page 4 .
2
Disconnect the notebook from the optional port replicator by following
the instructions in
“Disconnecting from the port replicator” on page 7 .
3
Turn the notebook over so the bottom is facing up.
4
Remove the main and optional secondary batteries by following the
instructions in
“Removing the batteries” on page 8 .
5
Remove the hard drive kit by following the instructions in “Replacing the
hard drive kit” on page 21 .
Phillips #0 screwdriver
4 chrome 3 × 3.5 mm
(hard drive)