Gateway SZSL95IN0XXXXXXXX - Manual (Page 61)

www.gateway.com
55
Installing or replacing the
graphics card
Your computer has either a graphics card installed or a spacer
(a placeholder for the graphics card slot) installed. If the spacer
is installed, your computer’s system board provides the
graphics abilities for your system.
To install or replace the graphics card:
1 Open the back panel by following the instructions in
“Opening and closing the case” on page 46 . The
computer should be face-down on a soft, stable,
non-marring surface before continuing.
2 If the computer has been running within the last few
minutes, allow the graphics card cool down for about
five minutes before continuing.
3 Remove the two screws that secure the graphics card or
graphics card spacer to the computer.
Tools
• Phillips screwdriver
Warning
The graphics card may be extremely hot. Touching the graphics
card while hot may result in physical injury. Allow the graphics card to
cool before continuing.
Screws
8512740.book Page 55 Thursday, September 27, 2007 2:43 PM