Gateway SZSL95IN0XXXXXXXX - Manual (Page 55)

www.gateway.com
49
3 If you are removing an old module from a memory slot,
spread the two metal tabs away from the sides of the
memory module. The module flips up at a 30° angle.
If you are removing a module from the lower memory
slot, you must first remove the module from the upper
slot.
4 Pull the old memory module out of the slot.
5 Slide the new module into an available memory slot at
a 30° angle, then press it down until it clicks into place.
6 Close the back panel by following the instructions in
“Opening and closing the case” on page 46 .
7 Return your computer to its upright position, then
reconnect all cables.
8 Turn on your computer. Windows starts and the
Windows desktop appears.
9 Click (Start), right-click Computer, then click
Properties. The amount of memory now installed in
your computer is displayed.
Upper memory slot
Lower memory slot
8512740.book Page 49 Thursday, September 27, 2007 2:43 PM