Fostex D-108 - Manual (Page 9)

D-108 Owner's Manual (Names and Functions)
9
D-108
8TRACK DIGITAL RECORDER
OPTICAL
PREVIEW
ENVELOPE
LOCATE REC END
VARI PITCH
RECORD STOP PLAY REWIND F FWD
PUNCH LOCATE REHEARSAL
TAKE
TIME BASE SEL
RECALL STORE HOLD/
/NO
EXIT
/YES
EXECUTE
DISP SEL
REDO UNDO ERASE
AUTO RTN
COPY MOVE PASTE
CLIPBOARD
AUTO RTN
OUT IN AUTO PLAY
AUTO PUNCH
START OUT IN END
TC IN LOCKED HD ACCESS
RECORD TRACK
1/9 2/10 3/11 4/12 5/13 6/14 7/15 8/16
PGM SEL
PUNCH
IN / OUT
LOCATE ABS 0
CLIPBOARD PLAY
AUTO
SHIFT
9 10
13
14
15
17
18
16 19 20
24
23
22
21
25 26 39 38 37 36 35 32
34 29 30 31 33
42
43
41 40
11 12
27
28
8
AUTO RTN
AUTO PLAY
AUTO RTN
AUTO PLAY
AUTO RTN
AUTO PLAY
AUTO RTN
AUTO PLAY
9. Meter display
This meter display shows the signal level and settings.
* Refer to the “Display section” on page "18."
10. Record Track Select key [RECORD TRACK]
Select "SAFE-READY" of the track to record. Pressing the
key once will cause the corresponding track to enter the
READY mode, and the track displayed ( ) will flash.
Pressing the key again will cause the corresponding track
to enter the SAFE mode, and the track display to turn
OFF. When you only press the RECORD button in the
READY mode, the track that is READY will enter the input
monitor state, and the recording level can be adjusted.
Pressing the RECORD button again will put the system
back in the REPRODUCTION MONITOR state. You can
also use this key to select tracks to copy & paste, move &
paste, erase and other editing features, as well as to execute
the envelope feature.
* Refer to page "26" for details about the reproduction monitor
and the input monitor.
11. Shift key [SHIFT]
The connect slave unit's recording track is used in the
SAFE-READY mode if the D-108 is used as the master
system for MIDI slave synchronization.
12. Auto Play/Auto Return key
Pressing this key repeatedly will change Auto Play mode,
Auto Return mode, and Repeat mode On/Off as follows:
( : LED off, : LED light up)
Auto Play/Auto Return OFF
(All LEDs are off.)
Auto Play ON
(Only the AUTO PLAY LED is lit.)
Auto Return ON
(Only the AUTO RTN LED is lit.)
Auto Repeat ON
(Both AUTO PLAY and AUTO RTN
LEDs are lit.)
Auto Play mode:
In this mode, playback will start automatically after the
START point is located. This function is effective at any
locate points other than the ABS END point.
Auto Return mode:
When the END point is reached during playback, the
START point is automatically located in this mode. This
function is effective only when the START and END points
have been specified.
The Auto Return function is works only during playback. In the
recording mode, the START point will not be located automatically
when the END point is reached.
8. Controller Connection Cable
Connect this cable to the D-108 controller connection jack.
The panel comes with numbers for track 9-16, however, only
tracks 1-8 are operational.
* Refer to page "82" for details about using the SHIFT key.