Fostex D-108 - Manual (Page 58)

D-108 Owner’s Manual (Storing a Locate Point )
58
4. Select the LOCATE number desired using the JOG
dial.
LOCATE number from 00-99 are selectable. However,
select a number other then 00.
5. Next press the LOCATE key.
The time base (or bar/beat/clock) put on hold is stored
as data in the LOCATE number selected. The system will
return to the original time base when the storage process
is completed, and playback is resumed.
6. After completing the store process, press the STOP
button to stop the recorder section.
• You can omit Step 2 to speed operation.
• If you set “BAR/BEAT Resolution mode” in SETUP mode
to ON, the D-108 will round off the CLK value of the captured
bar/beat/clock value. That is, the locate point will be at the
beginning of the beat (00). Refer to page 120 for more
information.
Editing and storing locate data
If you know the position of the desired locate point, follow the steps below.
• Press the STORE key instead of the HOLD/> key in
Step 1 and omit Step 3 to speed operation.
1. Press the HOLD/> key while the D-108 is stopped.
The currently-displayed time value (or bar/beat/clock value)
is captured and the D-108 enters data edit mode.
2. Press the HOLD/> key, or turn the SHUTTLE dial to
move the flashing cursor on the time value digit, and
use the JOG dial to increase or decrease the value.
3. Press the STORE key.
5. Press the LOCATE key.
The edit time data is stored as the time data for the
selected LOCATE number.
4. Select the LOCATE number desired using the JOG
dial.
5
2
3
8 TRACK DIGITAL RECORDER
PREVIEW
ENVELOPE
LOCATE REC END
VARI PITCH
RECORD STOP PLAY REWIND F FWD
PUNCH LOCATE REHEARSAL
TAKE
TIME BASE SEL
RECALL STORE HOLD/
/NO
EXIT
/YES
EXECUTE
DISP SEL
REDO UNDO ERASE
AUTO RTN
COPY MOVE PASTE
CLIPBOARD
AUTO RTN
OUT IN AUTO PLAY
AUTO PUNCH
START OUT IN END
TC IN LOCKED HD ACCESS
RECORD TRACK
1/9 2/10 3/11 4/12 5/13 6/14 7/15 8/16
PGM SEL
PUNCH
IN / OUT
LOCATE ABS 0
CLIPBOARD PLAY
AUTO
SHIFT
POWER
OPTICAL
1, 2
2, 4