beautypg.com

Auto play, Auto return – Fostex D-108 User Manual

Page 61

background image

D-108 Owner’s Manual (Locate Function)

61

• You can set a preroll time in the [Preroll Time ?] menu in

SETUP mode so that the D-108 will start playback preroll

time before the locate point.

You can set the preroll time from 0 to 10 seconds. Refer to

the chapter “Changing the Initial Settings (SETUP Mode)”

on page 111.

Automatic locating to the AUTO RTN START point

subsequent to playback to the AUTO RTN END point.

Note:

This function is effective within 24 ABS hours. Therefore, if playback continues over the recording end point, the

D-108 will still continue counting the time. Also, when the D-108 locates ABS REC END, it will continue counting the time

from the recording end point. (However, the D-108 does not access the disk after reaching the recording end point.)

AUTO PUNCH IN point

LOCATE

PLAYBACK

LOCATE

PLAYBACK

LOCATE
START

LOCATE
START

AUTO RTN END point

AUTO RTN START point

STOP

PLAYBACK

LOCATE

PLAYBACK
START

Auto Play

The Auto Play function allows the D-108 to start play back automatically from the located point.
AUTO PLAY mode should be turned on before you execute the Direct Locate function described above.

1. Press the AUTO RTN/AUTO PLAY key to turn on

the [AUTO PLAY] LED.

2. Press the LOCATE key, or memory key.

The D-108 locates the point and plays as shown in the
diagram.

3. Press the STOP button to stop the D-108.

Auto Return

This function allows the D-108 to play data up to the AUTO RTN END point, then automatically locate the AUTO
RTN START point as shown in the diagram below. To enable this function, AUTO RTN mode should be on and the
AUTO RTN START point and AUTO RTN END point should already be set.

1. Store the AUTO RTN START and AUTO RTN END

points.

Refer to the chapter “Storing a Locate Point (Edit Point)”
on page 54 for information on storing the desired points
in the AUTO RTN START key and the AUTO RTN END
key.

2. Press the AUTO RTN/AUTO PLAY key to turn on

the [AUTO RTN] LED.

3. Start playback a little before the AUTO RTN END

point.

The D-108 operates as shown in the diagram.

• You can set a preroll time in the [Preroll Time ?] menu in

SETUP mode so that the D-108 will start playback preroll

time before the locate point. You can set the preroll time

from 0 to 10 seconds. Refer to the chapter “Changing the

Initial Settings (SETUP Mode)” on page 111.

AUTO RTN

AUTO PLAY

AUTO RTN

AUTO PLAY