Fostex VF160EX - Manual (Page 134)

134
You cannot register the “001BAR“ of “001BAR 4/4 .”
Correcting the Registered Time Signature
1. Under the previous “Confirmation display,” select bar/
time signatures to be changed and press the [ENTER/
YES] key.
2. Input the desired signature via the [JOG] dial and press
the [ENTER/YES] key.
The newly input signature will be setup.
Be careful because this procedure wipes out the tempo
setting as well as time signature setting.
1. Under the above “Confirmation display,” select “All Clear”
and press the [ENTER/YES] key.
A following display of “ All Clear ,” “ SURE ? ” will flash.
This indicates the standby mode for clearing all signature
setting data and the tempo data.
Clearing All Time Signature/Tempo Data
1. Under the above “Confirmation display,” select
“-002BAR Offset” and press the [ENTER/YES] key.
The “-002” display will change to flashing.
Changing the Bar Offset Figure
Bar You can enter are from 001 to 999 .
Time 1/4, 2/4, 3/4, 4/4, 5/4, 1/8, 3/8, 5/8, 6/8, 7/8, 8/8
Signature or DEL
DEL is used to deleted time signature data.
The following bar numbers and time signatures can be
entered via the
[JOG] dial.
6. Next, to register other bar and time signature, repeat
steps 2 through 5.
7. Upon completion of registering, press the [EXIT/NO] key
(or the [STOP] key) and exit from the SETUP mode.
Deleting a Time Signature
3. Press the [ENTER/YES] key.
The selected measure/signature setting will be deleted.
4. After deleting, press the [EXIT/NO] key (or [STOP] key)
to exit from the SETUP mode.
Take care because this procedure wipes out the tempo
setting as well as time signature setting.
1. Under the above “Confirmation display,” select bar/time
signatures to be deleted and press the [ENTER/YES] key.
2. Press the [ENTER/YES] key again to make “ */* ” to flash
and input “DEL” via the [JOG] dial.
2. Press the [ENTER/YES] key.
Except for the initial setting “001BAR 4/4 ,” other time
signature settings and the tempo setting will be cleared
at the same time.
3. Press the [EXIT/NO] key (or STOP key) to exit from the
SETUP mode.
2. Input the desired offset value with the [JOG] dial and
press the [ENTER/YES] key.
Offset value can be input in the “-2” through “-9” range.
3. After correction, press the [EXIT/NO] key (or [STOP] key)
to exit from the SETUP mode.
Flashing
Flashing
Flashing
Flashing
3. Upon finishing, press the [EXIT/NO] key (or [STOP] key)
to exit from the SETUP mode.
Time 1/4, 2/4, 3/4, 4/4, 5/4, 1/8, 3/8, 5/8, 6/8, 7/8, 8/8
Signature or DEL
DEL is used to deleted time signature data.