FUJITSU TX120 - Manual (Page 52)

52 Operating Manual TX120
Cleaning the server Starting up and operation
To find out how to operate ServerStart and for further information, refer to the
corresponding manual (see “Literature” on page 77 ).
If you are using ServerStart , you can skip the following section on how to
configure the server and install the operating system. Continue from section
“Cleaning the server” on page 52 .
5.4.3 Configuration without ServerStart
Configuring onboard SAS controller
Configure the controller as described in section “Configuring onboard SAS
controller” on page 51 .
Operating system installation
Ê Insert the CD/DVD for the operating system you want to install.
Ê Reboot the server.
Ê Follow the instructions on screen and in the manual for the operating
system.
5.5 Cleaning the server
V
CAUTION!
Switch the server off and disconnect the power plugs from the grounded
shockproof sockets.
Do not clean any interior parts yourself; leave this job to a service
technician.
Do not use any cleaning agents that contain abrasives or may corrode
plastic.
Ensure that no liquid enters the system. Ensure that the ventilation areas
of the server and the monitor are clear.
Clean the keyboard and the mouse with a disinfecting cloth.
Wipe the server and monitor casing with a dry cloth. If particularly dirty, use a
cloth that has been moistened in a mild domestic detergent and then carefully
wrung out.