FUJITSU TX120 - Manual (Page 49)

TX120 Operating Manual 49
Starting up and operation Switching the server on and off
5.3 Switching the server on and off
V
CAUTION!
If nothing appears on the screen but flickering stripes after switching on
the server, switch the server off immediately (see section
“Flickering
stripes on monitor screen” on page 57 ).
The On/Off button does not disconnect the server from the mains. To
disconnect from the mains completely, remove the power plug(s).
Switching the server on
The power-on indicator (item 5 in figure 9 on page 44 ) lights orange.
– Starting up for the first time:
Ê Press the On/Off button (item 11 in figure 9 on page 44 ).
The power-on indicator lights up green (item 5 in figure 9 on page 44 ).
Ê Insert ServerStart disc 1 in the CD/DVD drive.
Ê Follow the on-screen instructions (see also section “Configuring onboard
SAS controller” on page 51 or section “Configuration without Server-
Start” on page 52 ).
– System already installed:
Ê Press the On/Off button (item 11 in figure 9 on page 44 ).
The power-on indicator lights up green (item 5 in figure 9 on page 44 ).
The server is switched on, performs a system test and boots the
operating system.