Force10 Networks Force10 TeraScale E-Series E1200i - Manual (Page 83)

Installing and Maintaining the E1200i System 83
6.
interface
management port
config 100m
interface
management port
config 10m
interface
management port
config
auto-negotiate
interface
management port
config no
auto-negotiate
interface
management port
config full-duplex
interface
management port
config half-duplex
interface
management port
config show
• (OPTIONAL) Use these commands to set the speed and duplex settings
for the Management interface.The default setting is full-duplex and
auto-negotiation.
• Use the
interface management port config show
command to
view the Management interface’s physical settings.
7.
show interface
management
ethernet
interface
management
ethernet ip
address ip-address
ip-address-mask
• Use the
show interface management ethernet
command to
display the IP address and network mask of the management Ethernet
port.
• If the
show
command output does not display configured IP address
information, use the
interface management ethernet ip
address ip-address ip-address-mask
command to set the IP
address of the Management Ethernet port for network (ftp/tftp) operating
system boot.
Step Command Task (continued)
BOOT_USER # boot change primary
'.' = clear field; '-' = go to previous field
boot device : flash
file name : /E1200-3.x.bin
BOOT_USER # boot change default
'.' = clear field; '-' = go to previous field
boot device : flash
file name : /E1200-3.x.bin
BOOT_USER #