FUJITSU 10 ppm User Manual
Page 51
3-6
User’s Manual
Clearing the Buffer and Reinitializing the Printer (
RESET
)
Pressing and holding down
RESET
for five or more seconds clears the
print buffer and tells the printer to initialize itself. You might use this
function if you cancel a print job in the middle and want to clear the
printer and start over. In this case, permanently downloaded fonts are
removed by the initialization process. You must download the fonts again.
Printing a Status Report (
SELF TEST
)
The status report function prints a page that summarizes printer option
settings and shows samples of resident fonts.
To print a status report, follow these steps:
1. Make sure that the message display indicates
READY
with the
ONLINE and DATA indicators off.
2. Press the
SELF TEST
button for five or more seconds.
The message changes to
SELF TEST
with the DATA indicator
flashing and the status report begins printing. After printing, the
printer returns to the original state. See Figure 3-2.
Notice:
If the FPS card is installed, the status report is for either the PCL
emulation or the FPS emulation depending on the emulation you
used for printing the last document; however, the status report is for
the FPS emulation if it is printed immediately after the printer is
turned on. To clearly select the report, use the test menu in setup
mode. See Chapter 3.
Control Panel Functions
☞