FUJITSU 10 ppm - Manual (Page 122)

User’s Manual 6-13
SOLVING
PROBLEMS
Error Indications
Message Causes and solutions
MOTOR FAILURE n Cause: Malfunction in the feed motor, etc.
Solution: If the error recurs, consult your
dealer for service.
NO PROCESS UNIT Cause: No print unit is installed.
Solution: Install the print unit.
OVERRUN ERROR Cause: Incomplete in extracting
compressed data
Solution: Press the
CONT. button.
PAPER JAM n Cause: Paper jam in the specified position
Solution: Clear the jammed paper from the
following area:
0: Pick roller, 1: Entry to paper path
2: Paper path, 3: Ejection from paper path
PS ERROR mn Cause: A PostScript error
Solution: If the error recurs, consult your
dealer for service.
Source PAPER OUT Cause: Paper out in the specified paper
source
Solution: Supply paper.
STACKER FULL Cause: Paper stacker full
Solution: Remove paper from the paper
stacker.
SYSTEM ERROR n Cause: A system error on the controller
board
Solution: If the error recurs, consult your
dealer for service.
TRAY n MISS SET Cause: Paper tray installed incorrectly
Solution: Install the paper tray.
TONER EMPTY Cause: Toner runs out.
Solution: Replace toner bottle.