FUJITSU 10 ppm - Manual (Page 34)

User’s Manual 1-19
GETTING
STARTED
11.When all files have been copied and the driver is installed, a dialog will
appear querying the result of test page printout. Depending on
whether the test page was printed correctly or not click “Yes” or “No”.
The Fujitsu PrintPartner 10V or 14V Windows 95 printer driver is now
installed.
For further details, see the appropriate country version of the driver’s
Readme file.
Your printer should be set up and connected to your computer. This
section explains how to test your installation setup by printing a trial
document from an application program under Windows. To test the
printer alone, without your computer, you can use the status report
printing which does not require the use of a computer. See Printing a
Status Report in Chapter 3.
Turn on your printer and observe the initialization sequence. If no RAM
(extra memory) cards have been installed, the sequence lasts about one
minute, during which the following events occur:
• The printer conducts a number of self-checks.
• The main motor rotates to check mechanical functions and clean the
drum.
• The message display indicates READY , indicating the printer is ready for
printing.
The following procedures show you how to print your trial document.
To print a trial document, follow these steps:
1. Start Windows and a Windows application.
2. Open your trial document.
Select an existing or start a new document. Choose a small document
for the first trial.
3. Select PP10V or PP14V as the document printer.
In most programs, you make the selection in a print menu. Consult
your program documentation for the exact procedure.
Printing Your First Document
Printing Your First
Document