FUJITSU SPARC ENTERPRISE M5000 - Manual (Page 220)

12-10 SPARC Enterprise M4000/M5000 Servers Service Manual • August 2009
■
Set up the CPU operational mode on the domain.
Refer to Chapter 2, “Setting Up XSCF,” in the Sun SPARC Enterprise
M3000/M4000/M5000/M8000/M9000 Servers XSCF User’s Guide for information
about these settings.
16. Use the setdomainmode(8) command to disable the autoboot function of the
domain.
Refer to the Sun SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers
XSCF User’s Guide and the setdomainmode(8) man page for more information.
17. Power on the new domain.
18. Confirm that the target domain has been correctly started.
19. Confirm that no error has occurred.
20. Install a version of Solaris OS that supports SPARC64 VII processors.
Note – The SPARC64 VII processors are supported by the XCP firmware (beginning
with XCP 1070) and Solaris software. For more information about these minimum
software and firmware requirements, see the latest version of the Product Notes (no
earlier than the XCP 1070 edition) for your server.
For information about network-based installations, refer to Solaris 10 8/07
Installation Guide: Network-Based Installations (part 820-0177).
21. Use the setdomainmode(8) command to enable the autoboot function of the
domain.
The autoboot function is applied by a domain reboot. For more information, refer
to the Sun SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers XSCF
User’s Guide and the setdomainmode(8) man page.
XSCF> poweron -d domain_id
XSCF> showlogs power
XSCF> showlogs error -v
XSCF> showstatus