Furuno UAIS TRANPONDER FA-150 User Manual
Page 44
1. OPERATION
1-33
20. LON of RIGHT TOP is selected; press the ENT key. Enter longitude for the
right-top position (northeast point) of the AIS operating area then press the
ENT key.
21. LAT of LEFT BOTTOM is selected; press the ENT key. Enter latitude for the
left-bottom position (southwest point) of the AIS operating area then press
the ENT key.
22. LON of LEFT BOTTOM is selected; press the ENT key. Enter longitude for
the left-bottom position (southeast point) of the AIS operating area then
press the ENT key.
Note: The available range is 20-200 nm. If the area contains overlapping
data the older data will be erased.
RIGHT-TOP
LEFT-BOTTOM
ZONE
1-8 nm
20-200 nm
20-200 nm
23. Press the MENU key. The prompt shown below appears.
SAVE CHANNEL.
ARE YOU SURE?
YES
NO
24. Press ◄ to select YES then press the ENT key.
Note:
If a combination other than that shown in the table at step 13 is
selected, the message “ILLEGAL MODE WAS SELECTED PRESS ANY
KEY.” appears.
25. Press the DISP key to close the menu.
Note: If you enter invalid data, the message “OUT OF RANGE!: OO” appears.
Press any key to escape. Reenter data.