FujiFilm F601 - Manual (Page 59)

116 117
Notes on the SmartMedia ™
■SmartMedia
The SmartMedia card supplied with your FinePix F601
ZOOM camera is a new image recording medium
developed especially for use in digital cameras. Each
SmartMedia card contains a built-in semiconductor
memory chip (NAND flash memory) which is used for
storing digital image data.
Because the data is stored electronically, the stored image
data can be erased from the card and new data recorded.
■SmartMedia with IDs
The SmartMedia ID is a SmartMedia that has an
individually assigned identification number. SmartMedia
ID cards can be used with devices that use ID numbers
for copyright protection or other purposes. This camera
accepts SmartMedia ID cards in the same way as
conventional SmartMedia cards.
■Storing Data
In the situations listed below, recorded data may be
erased (destroyed). Please note that Fuji Photo Film
Co., Ltd. accepts no responsibility whatsoever for the
loss (destruction) of recorded data.
✽When the SmartMedia is used incorrectly by the
owner or a third party
✽When the SmartMedia is exposed to static electricity
or electrical noise
✽When the battery cover is opened or the SmartMedia
removed and the camera is then switched off during
data recording, during data erasing (SmartMedia
formatting) or during frame advance when images are
being played back.
Back up important data onto another medium.
(MO disk, floppy disk, hard disk, etc.)
■Notes on Handling SmartMedia
h Take care to hold the SmartMedia straight when you
load it into your camera.
h Never remove the SmartMedia or switch the camera
off during data recording, during data erasing
(SmartMedia formatting) or during frame advance
when images are being played back. These actions
could result in damage to the SmartMedia.
h Use only the SmartMedia specified for use with the
FinePix F601 ZOOM. The use of other SmartMedia
could damage the camera.
h SmartMedia are precision electronic devices. Do not
bend, drop, or subject SmartMedia to excessive
shocks.
h Do not use or store SmartMedia in environments
likely to be affected by strong static electricity or
electrical noise.
h Do not use or store SmartMedia in very hot, humid or
corrosive environments.
h Take care not to touch the SmartMedia’s contact area
or allow the area to become soiled. Use a dry lint-free
cloth to wipe away any soiling that does occur.
h To avoid damage caused by static electricity, always
use the special static-free case provided during
transportation or storage, or keep the SmartMedia in
a storage case if available.
AC Power Adapter
Use only the AC-5VS/AC-5VHS AC Power Adapter
with your FinePix F601 ZOOM Digital Camera. The use
of other AC power adapters may result in damage to
your camera.
h The AC Power Adapter is only intended for indoor
use.
h Push the connection cord plug firmly into the DC input
socket.
h When you unplug the connection cord from the DC
input socket, switch the camera off and pull the plug
out by grasping the plug itself (not by pulling the
cord).
h Do not use the AC power adapter with any device
except the specified device.
h During use, the AC power adapter will become hot to
touch, but this is not abnormal.
h Do not disassemble the AC power adapter. Doing so
could be dangerous.
h Do not use the AC power adapter in a place with high
temperature and high humidity.
h Do not drop or subject the AC power adapter to
strong shocks.
h The AC power adapter may emit a humming noise,
but this is not abnormal.
h If used near a radio, the AC power adapter may
cause static, so play the radio in a distant place.
✽Very occasionally, DC output will be prevented by the
operation of the internal protection circuit. In this
event, unplug the AC-5VS/AC-5VHS AC power
adapter from the power socket for a few moments
and then plug it in again. This will restore DC output.
■ Specifications (AC-5VS/AC-5VHS)
Power Supply AC 100V to 240V, 50/60Hz
Rated Input Capacity 12W (U.S.A. and Canada)
0.15A to 0.24A (other countries)
Rated Output DC 5.0V 1.5A (U.S.A. and Canada)
DC 5.0V 2.0A (other countries)
Temperature During Use 0°C to +40°C (+32°F to +104°F)
(U.S.A. and Canada)
0°C to +45°C (other countries)
Storage Temperature -10°C to +70°C (+14°F to +158°F)
Dimensions (MAX.)
47 mm × 20 mm × 72 mm
(1.9 in. × 0.8 in. × 2.8 in.)
(W × H × D) (U.S.A. and Canada)
49 mm × 40 mm × 65 mm
(W × H × D) (U.K.)
49 mm × 31 mm × 65 mm
(W × H × D) (other countries)
Mass (Weight) Approx. 120 g (4.2 oz.) (U.S.A. and Canada)
Approx. 200 g (7.0 oz.) (U.K.)
Approx. 180 g (6.4 oz.)
(other countries)
Connection Cord Length Approx. 2 m (6.6 ft.)
✽ Please note that specifications and characteristics are
subject to change without notice.
Notes on the Power Supply