FUJITSU fi-6130 - Manual (Page 174)

Thickness: 0.056 inches / 1.4 mm or less
Material:
PVC (Poly vinyl chloride) or PVCA (Polyvinyl chloride acetate)
Note: Before scanning your card, test with a dummy card of the same material to
see if it can be fed into the ADF properly.
●
Cards that are excessively rigid or less flexible may not feed smoothly and excessive
noise may occur.
Note: If the cards do not feed smoothly, try:
- Scanning one card at a time.
- Enabling [Automatic Paper Size Detection]. For how to configure this setting, see
Section " 3.10 Correcting Skewed Documents. "
- Raising the resolution.
●
Cards should be clean from oil and without labels.
●
Cards cannot be scanned when the imprinter is installed.
All Rights Reserved. Copyright 2007 © PFU LIMITED