FUJITSU MPE3XXXAT User Manual
Page 98
C141-E077-01EN
5 - 31
Table 5.5
Information to be read by IDENTIFY DEVICE command (2 of 4)
*1 Word 0: General configuration
Bit 15: 0 = ATA device
0
Bit 14-8: Vendor specific
0
Bit 7: 1 = Removable media device
0
Bit 6: 1 = not removable controller and/or device
1
Bit 5-1: Vendor specific
0
Bit 0: Reserved
0
*2 Number of Cylinders, *3 Number of Heads,
*11 Total number of user addressable sectors (LBA mode only.)
MPE3064AT
MPE3102AT
MPE3136AT MPE3170AT
MPE3204AT
MPE3273AT
*2
X‘3462’
X‘3FFF’
*3
X‘0F’
X‘10’
*11 X‘00C15DC2’ X‘01316CDC’ X‘01973C40’
X‘01FD0AC4’
X‘0262D9B8’ X‘032E7960’
*4 Word 10-19: Serial number; ASCII code (20 characters, right-justified)
*5 Word 23-26: Firmware revision; ASCII code (8 characters, Left-justified)
*6 Word 27-46: Model number;
ASCII code (40 characters, Left-justified), remainder filled with blank code (X'20')
One of the following model numbers;
MPE3064AT, MPE3102AT, MPE3136AT, MPE3170AT, MPE3204AT, MPE3273AT
*7 Word 49: Capabilities
Bit 15-14: Reserved
Bit 13: Standby timer value 0 = Standby timer values shall be managed by the device
Bit 12: Reserved
Bit 11: IORDY support 1=Supported
Bit 10: IORDY inhibition 0=Disable inhibition
Bit 9: LBA support 1=Supported
Bit 8: DMA support 1=Supported
Bit 7-0: Vendor specific
*8 Word 51: PIO data transfer mode
Bit 15-8: PIO data transfer mode X'02'=PIO mode 2
Bit 7-0: Vendor specific
*9 Word 53: Enable/disable setting of word 54-58 ,64-70 and 88
Bit 15-3: Reserved
Bit 2: Enable/disable setting of word 88 1=Enable
Bit 1: Enable/disable setting of word 64-70 1=Enable
Bit 0: Enable/disable setting of word 54-58 1=Enable