Furuno GP-7000F - Manual (Page 83)

9. DATA TRANSFER
9-3
9.1.4 Playing back data from a memory card
Data (track, waypoints, routes) can be loaded from a memory card and
displayed on the screen. This feature is useful for observing past data.
1. Insert the memory card to play back into the selected slot.
2. Open the MEMORY CARD list.
3. Rotate the [ENTER] knob to choose LOAD and then push the [ENTER] knob.
9.2 Sending/Receiving Data
You can send/receive waypoints and routes from/to a PC or another GP-7000/F
to the internal memory, through the NMEA1, NMEA 2 or RS-232C port at the
rear of the display unit.
9.2.1 Sending/receiving waypoints data
You may send/receive all waypoints data as follows. When sending data,
set the connected equipment for receiving.
1. Connect the PC or another GP-7000/F to the equipment.
2. Choose INPUT/OUTPUT from the ADVANCED menu.
3. When sending data, follow steps shown below.
a) Choose NMEA 1 OUTPUT, NMEA 2 OUTPUT or RS232 3 OUTPUT
appropriately.
The sentence window appears.
GLL
VTG
BWR
DBT
DPT
MTW
VHW
WCV
APA
APB
HDG
BOD
XTE
RMA
RMB
RMC
GGA
HSC
AAM
GTD
MWV
ZDA
WPL
RTE
TLL Out On
On
Off
Off
Off
Off
Off
Off
Off
On
Off
Off
Off
Off
On
On
Off
Off
Off
Off
Off
Off
On
On
On
Sentences window
b) Choose WPL and then set it on.
Note: When receiving the waypoint data on PC, set all sentences other than
WPL off.