Fluke Series II - Manual (Page 74)

Connectivity Tests
Introduction
6
6-3
Press IP Ping or NetWare Ping as appropriate.
Entering IPX Addresses
From the Connectivity Tests display, press (IP &
NetWare Ping), then press the (NetWare Ping) tab to
access the NetWare Ping Configuration display (Figure 6-
4).
ace605s.bmp
Figure 6-4. NetWare Ping
The NetWare ping test requires only the IPX node
address of the station you want to ping. If you want the
Network Assistant to find the station’s network address,
enter 00000000 as the network address. Press an
address box to access the keypad for entering IPX
addresses.
ace604s.bmp
Figure 6-5. IP Ping