Fluke Series II - Manual (Page 101)

OneTouch Series II
Users Manual
7-18
Note
The illegal sized frames of 60 and 1520 bytes
will not pass through a router and may not pass
through a switch.
7. Select IP as the frame type.
8. Configure the Target IP Address box by pressing
the box and entering the address from the displayed
keypad.
9. Press (Start Traffic) to run Traffic Generator.
Press (Stop Traffic) to stop the Traffic
Generator.
The generated traffic for IP Mode consists of an IP frame
containing all zeros in the data field.
Traffic is transmitted to the specified Target IP Address. If
the Target IP Address specifies a station on the local
segment, the station must respond to an ARP request
sent by the Network Assistant before traffic generation is
started. If the Target IP address specifies a non-local
station, the default router must respond to an ARP
request sent by the Network Assistant before traffic
generation is started.
MAC and IP Mode Results
Traffic Generator displays MAC and IP mode results as it
is running. You can adjust Frames/second and Frame
Length while Traffic Generator is running to see the
effect of traffic loading on your network (MAC mode) or a
station (IP mode).
Two meters show the overall network utilization. One
meter shows the current measured frame rate (in frames
per second) and the other meter shows the utilization
percentage. Figure 7-10 shows MAC or IP mode sample
results.