Fluke Series II - Manual (Page 34)

Autotest and Central Setup
NetWare Print Server List
2
2-19
ace218s.bmp
Figure 2-17. Address Entry Keypad
To move the cursor, use the arrow keys or press the
desired octet within the IP address box.
To quickly move between address octets, press the “.”
key, then press the octet you want to modify.
After entering the address, press OK.
Using DHCP to Get an IP Source Address
The DHCP feature lets you use Dynamic Host
Configuration Protocol to automatically get an IP source
address for your Network Assistant.
To activate DHCP, press (IP Config) from the Central
Setup screen; then select DCHP. When you press
(Get Address), the Network Assistant requests to lease
an IP address from a DHCP server (Figure 2-18). The
DHCP address request also occurs automatically if DHCP
is already selected when the Network Assistant detects a
link pulse.
If a DHCP server is found, the display shows the
accepted source IP address, DHCP server information,
and lease time. Pressing
(Get DHCP Address) again
restarts the DHCP process.