Hub autotest, Viewing hub capabilities – Fluke Series II User Manual
Page 68
NIC/Hub Tests
Introduction
5
5-3
Hub Autotest
Press
(Hub Autotest) to verify the connectivity
between the desktop and the Hub.
Hub Autotest checks the link pulse signal level and
queries the NetWare and NetBIOS servers to determine
the Hub’s ability to send and receive frames. If
successful, the Network Assistant displays the map that is
identical to AutoTest (Figure 5-3).
ace505s.bmp
Figure 5-3. Hub Autotest Display
Viewing Hub Capabilities
When the Network Assistant is connected to a hub and
has an active link state, press the Link label at the top of
the display to see the polarity of the received data. If your
Network Assistant has hardware revision 2.2 or later, you