Choosing the proper location, Exhaust, Electricity – LG 27 Inch Electric Smart Dryer Owners Guide User Manual

Page 12: Flooring, Ambient temperature

background image

12

INSTALLATION

Choosing the Proper

Location

WARNING

• Read all installation instructions completely

before installing and operating the appliance. It

is important that you review this entire manual

before installing and using the appliance.

Detailed instructions concerning electrical

connections and additional requirements are

provided on the following pages.

Exhaust

• The location must allow for proper exhaust

installation. A gas dryer must be exhausted to

the outdoors.

Electricity

Use an individual, grounded electrical outlet

located within 2 ft. (61 cm) of either side of the

appliance.

WARNING

• Do not install or store the appliance in an area

where it will be exposed to water and/or

weather.

NOTE

• Check code requirements that limit, or do not

permit, installation of the dryer in garages,

mobile homes or sleeping quarters. If you have

questions, contact your local building inspector.

Flooring

To avoid noise and vibration, the appliance must

be installed and leveled on a solidly constructed

floor with a maximum slope of 1 inch (2.5 cm). If

required, adjust the leveling legs to compensate

for the unevenness of the floor.

NOTE

• A sturdy floor is needed to support the total

appliance weight when loaded. The combined

weight of additional appliances should also be

considered.

• Clothes may not tumble properly, and automatic

sensor cycles may not operate correctly if the

appliance is not level.

• For garage installation, you will need to place the

appliance at least 18 inches (45.7 cm) above the

floor. The standard pedestal height is 15 inches

(38 cm). You will need 18 inches (45.7 cm) from

the garage floor to the bottom of the appliance.

Ambient Temperature

Install the appliance in an area where the

temperature is over 45

(7

).

If the temperature around the appliance is too low,

the appliance might not shut off at the end of an

automatic cycle. This can result in longer drying

times.

en-us_main.book.book Page 12 Wednesday, December 7, 2022 8:18 AM