AJA ROI DVI to SDI Mini-Converter - Manual (Page 34)

ROI Series Mini-Converter v1.7 34 www.aja.com
Analog Out Map
This control selects which two SDI embedded audio channels receive the
incoming L R analog audio when Embed into SDI is set to Analog or Analog +
HDMI. Choose from Ch 1-2, Ch 3-4, Ch 5-6, or Ch 7-8.
ROI-DP Audio Tab Screen
In default mode, the ROI passes up to eight channels of embedded audio from
the DisplayPort input to the SDI output, and mutes embedded audio to the
DisplayPort output.
Embed into SDI
Use this control to select which input audio is passed to the SDI output.
• DP - This selection passes the DisplayPort incoming audio to the SDI output
(up to 8 channels).
• Analog - This selection passes only the Analog audio input for inclusion into
the SDI audio stream. In this case, you can use the Analog Out Map pulldown
menu to select the specific channel pair you want to carry the signal.
• Analog + DP - This selection causes the Analog audio input to replace one
pair of the DisplayPort audio channels on the SDI output. The analog audio is
inserted on the channels defined by the Analog Out Map pulldown.
• None - No audio is output (mute) on the SDI output.
Embed into DP
Use this control to select which input audio is passed to the DisplayPort output.
• None - No audio is output (mute) on the DisplayPort output.
• DP - The DisplayPort incoming audio passes to the DisplayPort output (up to 8
channels).
DP Conversion
The Convert Rate button enables the ROI to convert incoming DisplayPort audio
between 32 kHz to 96 kHz to 48 kHz (the SDI native audio standard). If you don’t
want to convert, choose Pass Through .