AJA ROI DVI to SDI Mini-Converter - Manual (Page 18)

ROI Series Mini-Converter v1.7 18 www.aja.com
Figure 14. Example Mini-Config Screen
Select a USB port
and an attached
Mini-Converter
(name in parentheses)
Each connector is
labeled with the
signals currently
detected or
manually selected.
Firmware version
Serial
Number
Tabbed screens
Connection Status
Selecting a Mini-Converter with the pulldown menu causes this application to
connect to the selected converter. The graphic of Mini-Converter and text below
it provides:
• Type of converter
• Firmware version
• Serial number of the unit.
A status field at the bottom of the screen shows if your application is connected
and communicating with the Mini-Converter.
When configuring the Mini-Converter, select it from the top pulldown, view the
current settings and change any values. Making a change communicates that
new value to the Mini-Converter’s non-volatile memory.
Tabbed Screens
The Tabs delineate control screens with groups of controls for each type of task to
be performed.
The controls for the actual configuration parameters are specific to each Mini-
Converter type. When you Click on any of the tab buttons, the pane below
the tabs will change to match your tab selection. Any changes you make are
immediately applied and will be saved, overwriting previous settings.
NOTE: In this manual Mini-Config screens for the ROI-HDMI model are shown. Other ROI
models have similar screens, with a few exceptions that are noted.