XYZprinting Crazy3DPrint CZ-300 DIY 3D Printer - Manual (Page 32)

30
Info Screen
Prepare
Control
Print from SD
Change SD card
Main
CZ300ABS_FANCOVER.gcode
ABS PRINTING TIPS (FAN COVER)
In order to print with ABS, users may follow the steps below for better printing results.
PRINT THE FAN COVER FROM SD CARD
1) Insert a SD card to the slot; following select “Print from SD” and choose the file.
2) Prepare a roll of PLA filament and mount to the spool holder and start to print the fan cover.
INSTALL THE FAN COVER
1) Fan Cover Appearance.
2) Hold the fan cover slightly upward, and slowly push the fan cover bottom go in the fan bottom first.
3) Place the fan cover lock to the top of the fan, and slowly secure the top cover on the fan.
4) Check the top, back and bottom of the top cover and make sure the top cover completely mount on the fan.
Back View Side View
Bottom View