Extruder motor & z axis motor – XYZprinting Crazy3DPrint CZ-300 DIY 3D Printer User Manual
Page 14

12
1) Remove the screw from the Y-motor plastic cover; following place the ground wire ring under the plastic cover and
insert back the screw as well as tighten it.
The cable should be placed underneath the lower frame to prevent accidental pulling by the rod and the
print bed while printing
2) Plug the 6-pin yellow housing into the Y-motor socket; following plug the 3-pin yellowing housing into the Y-sensor
socket.
Extruder Motor & Z Axis Motor
Extruder Motor & Z-Motor wire separates long side wire and short side as below photo.
1 ) Plug the 6-pin housing of longer wire to the extruder motor socket as below illustration.
.
Extruder
Motor
2 ) Following plug the 6-pin housing of shorter wire to the Z axis motor socket as below illustration.