beautypg.com

Z-sensor, Securing print bed cable – XYZprinting Crazy3DPrint CZ-300 DIY 3D Printer User Manual

Page 15

background image

13

Z axis motor

3 ) Press the cable into the groove; following tie-up cable ties and cut them to a proper length.

Z-Sensor

1) Plug the 3-pin white housing into the Z-sensor socket.

2) Press the cable into the groove; following tie-up cable ties and cut them to a proper length.

SECURING PRINT BED CABLE

1) Take out the platform clip; following install the cable with it and clip back to the print bed.