Installing extruder module – XYZprinting Crazy3DPrint CZ-300 DIY 3D Printer User Manual
Page 11
9
Crosshead Screwdriver (*1)
6
4-5
Flathead Screwdriver (*1)
Accessory Preparation
3-3
Holder Lock (*1)
3-7
Screw M4x10 (*1)
11
Control Box & Power Supply (*1)
Tools Preparation (may use own tools if desired)
1) Insert two screws M4x8 through the holes on the metal plate of the extruder motor and lock up by the nuts.
Do not fully tighten both screw and nut first, and keep it freely moving.
2) Slide the extruder motor into the upper frame groove behind the Z-motor; following fully tighten the screws by using
a screwdriver.
The 3D printer parts can be referred to the names in the table of
CZ-300 APPEARANCE
. The height of
extruder motor should be parallel to the upper frame end – avoiding collision to the release arm when Z
shaft rising.
3) Insert the end cap into the upper frame hole and groove.
Users may use hand hardly press the end cap into the upper frame.
4)
Install the Z axis driving belt to the upper frame pulley.
INSTALLING EXTRUDER MODULE