XYZprinting Crazy3DPrint CZ-300 DIY 3D Printer - Manual (Page 16)

14
Accessory Preparation
2 Filament Tube (*1)
Tools Preparation (may use own tools if desired)
6 Crosshead Screwdriver (*1)
11 Control Box & Power Supply (*1)
Accessory Preparation
5 Random Color PLA Filament (300g)
INSTALLING FILAMENT TUBE
1) Fully insert the filament tube into the extruder motor and the extruder module.
FINAL CHECKING
Spool Holder Adjustment
1) Place the filament on the installed spool holder; following adjust it to a suitable position then tighten the screws to
secure the holder with the filament.
It is suggested that the filament spool should maintain 2 fingers interval to the upper frame.
Extruder Module Cable Adjustment
1) Make sure the length of the extruder module cable is placed at least 20cm from the holder lock to the module; so
that the extruder module can be left-right moving freely while printing.