beautypg.com

Firmware-update, Windows, Durch – XYZprinting Crazy3DPrint CZ-300 DIY 3D Printer User Manual

Page 26: Sam-ba), Firmware-update: windows (durch sam-ba)

background image

24

5)

At last, import ABS or PLA profile.

SLIC3R SOFTWARE – 3D PRINTER MANUAL SETTING

1) After installation, double-click the Slic3r icon to display the default page.

2) Select “File”, and click “Load Config…”.

3) Browse the file(s), select it, and click “Open”.

• Libraries\Documents\Crazy3DPrint CZ-300_ABS.ini

• Libraries\Documents\Crazy3DPrint CZ-300_PLA.ini

FIRMWARE-UPDATE: WINDOWS (DURCH SAM-BA)

This manual suggests users to update the printer firmware by using

Microchip SAM Boot Assistance (SAM-BA)

software, a programming tool to overwriting an existing firmware version where needed. It is assumed that users have

already had the software installed under relevant operating system.

Both versions of

SAM-BA 2.15

and

SAM-BA 2.18

are tested for the use of firmware update.

Users can download the up-to-date version of

CZ-300 firmware

from the website via:

https://www.crazy3dprint.com/support

Prepare the

USB cable

4-1

to connect the control box with your laptop or computer.

1) Press and hold the reset button – under the knob control; following turn on then off the power, wait 5 - 10 second

check monitor light off, then turn on power again. Check fan is stop running.

Reset Button